CISCO MDS 9124 CONFIGURATION GUIDE PDF

Example Cisco MDS Switch Default Port License Configuration. switch# show port-license Available port activation licenses are 0. Cisco MDS Family Quick Configuration Guide. OL Using the Switch Setup Utility Verifying the Module Status CHAPTER. 3. Configuring. Note If a Cisco MDS or switch is used as a core switch, only a nontrunking F PortChannel is supported. Trunking is not supported on.

Author: Kazilabar Mikasa
Country: Finland
Language: English (Spanish)
Genre: Medical
Published (Last): 6 September 2011
Pages: 136
PDF File Size: 18.34 Mb
ePub File Size: 8.63 Mb
ISBN: 614-1-18968-331-6
Downloads: 49480
Price: Free* [*Free Regsitration Required]
Uploader: Kajinos

I am not sure. Proudly powered by WordPress.

Page Information is repeated twice on the same page: You basically give the same settings for the IBM blade switch but this is a 24 port not a 20 port. It is worded as if it is a requirement but it is in fact not. This is very redundant and can be combined into one bullet. This should be made more clear. This is not correct. The autoreconfigure option takes immediate effect at runtime. Although it can be configured it has no effect. IP routing comfiguration not have to be enabled, unless there is a specific topology where IP routing is necessary.

  LINKSYS WRT310N MANUAL PDF

Should be 8 base ports, which can goto 8 or 16 additional ports. You must be logged in to post a comment.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata

Previous blog entries also dealt with storage, compute, virtualization and professional services. Should say Step 1 Enable the mgmt 0 interface. Caution The span drop-threshold can be changed only if no span sessions are currently active on the switch. Reconfiguration as in changing of domains is always disruptive.

Testing indicates that this is in fact enabled by default. I am not sure if this is valid.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata – Maximum Entropy

I think what is meant here is: Tuide there is either a mistake in the wording or the example. Obviously there was a part of this paragraph that got chopped off somewhere. Then states two bullets later: A disruptive reconfiguration may affect data traffic. If a domain is currently isolated due to domain overlap, and you later enable the autoreconfigure option on both switches, the fabric continues to be isolated. If you assign port number for physical portshow can mdd assign for ports ?

  LSL LENKER GUTACHTEN PDF

This however would be very nice to have in the documentation for IPS network simulator, an example showing complete configuration of Gigabit Ethernet interfaces and FCIP tunnels to go along with the Network Simulator. This situation can require several configuration tasks for each iSCSI host. You can nondisruptively reconfigure the fcdomain by changing the configured domains on the overlapping links and getting rid of the domain overlap.

About System Message Logging properly configured system message logging server. In this case, using the proxy initiator mode simplifies the configuration. Page shows with 8 base ports 8 licensed for growth. Leave a Reply Cancel reply You must be logged in to post a comment. This is not correct as this does not work. From time to time I will blog about other things of interest. This is not true. Cisco Documentation team has internally re-written this as: Page Document states: